Regulatory

FCC Statement (United States)

This device contains a radio transmitter. The radio module inside this product has been tested and found compliant with FCC regulations. The FCC ID for the radio module is:

FCC ID: 2AZARWT9011DCLBT50

FCC Part 15 Compliance Statement

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

FCC Interference Statement

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation.

If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

Caution: Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.

RF Exposure Information

This device has been evaluated for compliance with FCC RF exposure limits (Maximum Permissible Exposure, or MPE) for general population / uncontrolled exposure conditions as defined in 47 CFR 1.1310. The device operates at low power levels well within applicable MPE limits and does not require SAR (Specific Absorption Rate) testing.

To maintain compliance with FCC RF exposure requirements, use this device only under normal operating conditions. Do not attempt to modify the device or its antenna.

EU and UK Statement

The radio module integrated in the Dryve Golf 01 has been tested and found compliant with the essential requirements of the following EU directives and UK statutory instruments:

• Radio Equipment Directive (RED) 2014/53/EU
• UK Radio Equipment Regulations 2017 (SI 2017/1206)

A full Declaration of Conformity is available for download below.

Manufacturer / Responsible Party

Dryve Golf 01 is powered by the WitMotion WT9011DCL, manufactured by WitMotion Shenzhen Co., Ltd., Shenzhen, China.